Provided by: oss4-base_4.2-build2005-2ubuntu1_i386 bug


       oss_digi96 - RME Digi96 professional audio driver.


       Audio   driver  for  the  RME  Digi96  family  of  profressional  audio

       ·  Only 16 and 24/32 bit audio formats are supported.

       ·  All Digi96 family members  support  32kHz,  44.1kHz,  48kHz,  64kHz,
          88.2kHz and 96kHz. sampling rates.


       Note!  For  recording  you  need to set digi96.sync to INTERNAL and the
       values of digi96.mode and digi96.input  to  match  your  studio  setup.
       Otherwise recordings will fail with I/O error.

       There are several settings that can be changed using the ossmix program
       shipped with OSS. Note that some features don't work  with  all  Digi96
       family  members.  For  example  ADAT  mode is not supported by the base

       ·  digi96.mode <SPDIF|AESEBU|ADAT>: This setting  controls  the  output
          mode which can be S/PDIF (consumer), AES/EBU (professional) or ADAT.
          The input mode is detected automatically.  If ADAT input is detected
          the output mode will be switched to ADAT automatically (this doesn't
          work in the other direction).

       ·  digi96.sync <EXTERNAL|INTERNAL>: This setting tells if the  playback
          sampling rate is based on the internal oscillator or the sample rate
          detected  in  the  input  port.  See  also  the  definition  of  the
          digi96.worldclk setting.

       ·  digi96.input   <OPTICAL|COAXIAL|INTERNAL|XLR>:  Selects  the  active

       ·  digi96.sel <BYPASS|NORMAL>: When set to BYPASS the input signal will
          be   routed   directly   to   the   output  (also  sets  digi96.sync
          automatically to EXTERNAL). In  this  mode  audio  data  written  to
          /dev/dsp will be muted.

       ·  digi96.worldclk  ON|OFF:  Setting this control to ON will enable the
          optional worldclock input as the sample rate source  (overrides  the
          digi96.sync setting).

       ·  digi96.emph  ON|OFF:  Enables/disables the de-emphasis option on the
          analog (monitor) output connector.

       · <AUDIO|AC3>: Specifies if the output signal is audio  or
          AC3 data (sets the non-audio bit in the channel status data).




       /etc/oss4/conf/oss_digi96.conf Device configuration file


       4Front Technologies

                               05 February 2012                  oss_digi96(7)