Provided by: smp-utils_0.96-1_amd64 bug

NAME

       smp_rep_zone_man_pass - invoke REPORT ZONE MANAGER PASSWORD function

SYNOPSIS

       smp_rep_zone_man_pass  [--fpass=FP] [--help] [--hex] [--interface=PARAMS] [--phex] [--raw]
       [--report=RT] [--sa=SAS_ADDR] [--verbose] [--version] SMP_DEVICE[,N]

DESCRIPTION

       Sends a SAS Management Protocol (SMP) REPORT ZONE MANAGER PASSWORD function requests to  a
       SMP  target.  The  SMP  target  is  identified  by  the  SMP_DEVICE and the --sa=SAS_ADDR.
       Depending on the interface, the SAS_ADDR may be  deduced  from  the  SMP_DEVICE.  The  mpt
       interface uses SMP_DEVICE to identify a HBA (an SMP initiator) and needs the additional ,N
       to differentiate between HBAs if there are multiple present.

OPTIONS

       Mandatory arguments to long options are mandatory for short options as well.

       -F, --fpass=FP
              where FP is the name of a file which the password will be written to.  The  default
              action (in the absence of this option) is to write the password to stdout.

       -h, --help
              output the usage message then exit.

       -H, --hex
              output  the  response (less the CRC field) in hexadecimal. To only see the password
              in hexadecimal use the --phex option.

       -I, --interface=PARAMS
              interface specific parameters. In this case "interface" refers to the path  through
              the  operating  system  to  the  SMP initiator. See the smp_utils man page for more
              information.

       -p, --phex
              Output the password in comma separated hexadecimal bytes. In the  absence  of  this
              option  the  password  is  output  in  ASCII surrounded by single quotes.  Note the
              hexadecimal bytes are output with a hex indication (i.e. there is nos leading  "0x"
              nor trailing "h").

       -r, --raw
              send  the response (less the CRC field) to stdout in binary. All error messages are
              sent to stderr.

       -R, --report=RT
              set the 'report type' field in the SMP request. RT may take  these  values:  0  for
              report the current zone manager password (default); 1 is reserved; 2 for report the
              saved zone manager password; 3 for report the default zone manager password.

       -s, --sa=SAS_ADDR
              specifies the SAS address of the SMP target device. The mpt  interface  needs  this
              option  and  it  will  typically  be  an expander's SAS address. The SAS_ADDR is in
              decimal but most SAS addresses are shown in  hexadecimal.   To  give  a  number  in
              hexadecimal either prefix it with '0x' or put a trailing 'h' on it.

       -v, --verbose
              increase the verbosity of the output. Can be used multiple times.

       -V, --version
              print the version string and then exit.

CONFORMING TO

       The SMP REPORT ZONE MANAGER PASSWORD function was introduced in SAS-2 .

AUTHORS

       Written by Douglas Gilbert.

REPORTING BUGS

       Report bugs to <dgilbert at interlog dot com>.

COPYRIGHT

       Copyright © 2011 Douglas Gilbert
       This  software  is distributed under a FreeBSD license. There is NO warranty; not even for
       MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

SEE ALSO

       smp_utils, smp_conf_zone_man_pass, smp_zone_lock(smp_utils)