Provided by: freebsd-manpages_8.2-1_all bug


     ieee80211_input — software 802.11 stack input functions


     #include <net80211/ieee80211_var.h>

     ieee80211_input(struct ieee80211_node *, struct mbuf *, int rssi,
         int noise);

     ieee80211_input_all(struct ieee80211com *, struct mbuf *, int rssi,
         int noise);


     The net80211 layer that supports 802.11 device drivers requires that
     receive processing be single-threaded.  Typically this is done using a
     dedicated driver taskqueue(9) thread.  ieee80211_input() and
     ieee80211_input_all() process received 802.11 frames and are designed for
     use in that context; e.g. no driver locks may be held.

     The frame passed up in the mbuf must have the 802.11 protocol header at
     the front; all device-specific information and/or PLCP must be removed.
     Any CRC must be stripped from the end of the frame.  The 802.11 protocol
     header should be 32-bit aligned for optimal performance but receive
     processing does not require it.  If the frame holds a payload and that is
     not aligned to a 32-bit boundary then the payload will be re-aligned so
     that it is suitable for processing by protocols such as ip(4).

     If a device (such as ath(4)) inserts padding after the 802.11 header to
     align the payload to a 32-bit boundary the IEEE80211_C_DATAPAD capability
     must be set.  Otherwise header and payload are assumed contiguous in the
     mbuf chain.

     If a received frame must pass through the A-MPDU receive reorder buffer
     then the mbuf must be marked with the M_AMPDU flag.  Note that for the
     moment this is required of all frames received from a station and TID
     where a Block ACK stream is active, not just A-MPDU aggregates.  It is
     sufficient to check for IEEE80211_NODE_HT in the ni_flags of the
     station's node table entry, any frames that do not require reorder
     processing will be dispatched with only minimal overhead.

     The rssi parameter is the Receive Signal Strength Indication of the frame
     measured in 0.5dBm units relative to the noise floor.  The noise
     parameter is the best approximation of the noise floor in dBm units at
     the time the frame was received.  RSSI and noise are used by the net80211
     layer to make scanning and roaming decisions in station mode and to do
     auto channel selection for hostap and similar modes.  Otherwise the
     values are made available to user applications (with the rssi presented
     as a filtered average over the last ten values and the noise floor the
     last reported value).