NAME

       evtest - Input device event monitor and query tool

SYNOPSIS

       evtest /dev/input/eventX

       evtest --query /dev/input/eventX <type> <value>

DESCRIPTION

       The first invocation type displayed above ("capture mode") causes evtest to display information about the
       specified input device, including all the events supported by the device. It then monitors the device and
       displays all the events layer events generated.

       In the second invocation type ("query mode"), evtest performs a one-shot query of the state of a specific
       key value of an event type.

       type is one of: EV_KEY, EV_SW, EV_SND, EV_LED (or the numerical value)

       value can be either a decimal representation (e.g. 44), hex (e.g. 0x2c), or the constant name (e.g.
       KEY_Z) of the key/switch/sound/LED being queried.

       If the state bit is set (key pressed, switch on, ...), evtest exits with code 10. If the state bit is
       unset (key depressed, switch off, ...), evtest exits with code 0. No other output is generated.

       evtest needs to be able to read from the device; in most cases this means it must be run as root.

       evtest is commonly used to debug issues with input devices in X.Org. The output of evtest shows the
       information presented by the kernel; based on this information it can be determined whether a bug may be
       a kernel or an X.Org issue.

DIAGNOSTICS

       If evtest does not show any events even though the device is being used, the device may be grabbed by a
       process (EVIOCGRAB). This is usually the case when debugging a synaptics device from within X. VT
       switching to a TTY or shutting down the X server terminates this grab and synaptics devices can be
       debugged.

EXIT CODE

       evtest returns 1 on error.

       When used to query state, evtest returns 0 if the state bit is unset and 10 if the state bit is set.

SEE ALSO

       inputattach(1)

AUTHOR

       evtest was written by Vojtech Pavlik <vojtech@suse.cz[1]>.

       This manual page was written by Stephen Kitt <steve@sk2.org[2]>, based on that present in the lineakd
       package, for the Debian GNU/Linux system (but may be used by others).

NOTES

        1. vojtech@suse.cz
           mailto:vojtech@suse.cz

        2. steve@sk2.org
           mailto:steve@sk2.org

                                                   06/07/2013                                          EVTEST(1)