Provided by: freebsd-manpages_10.1~RC1-1_all
dpt — DPT RAID Controller SCSI driver
To compile this driver into the kernel, place the following lines in your kernel configuration file: device scbus device dpt For one or more EISA cards: device eisa For one or more ISA cards: device isa For one or more PCI cards: device pci To allow PCI adapters to use memory mapped I/O if enabled: options DPT_ALLOW_MEMIO Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): dpt_load="YES"
The dpt driver supports DPT RAID SCSI controllers. SmartRAID (PM3???) are "Enterprise" class cards, and SmartCache (PM2???) cards are in the "Workstation" class. The Gen 4 Smart Cache IV products were a re-issue of the Gen 3 utilizing upgraded (and cheaper to produce) silicon. The PM3334 (Smart RAID III) was not revamped as there was no upgraded silicon (68040 processor) and it was using the best DPT made. Note there has been customer confusion over the faster enterprise class card supported by this driver being an older generation. The Gen5 cards are supported by the asr(4) driver.
The dpt driver provides support for the following RAID adapters: · DPT Smart Cache Plus · Smart Cache II (PM2?2?, PM2022 [EISA], PM2024/PM2124 [PCI]) (Gen2) · Smart RAID II (PM3?2?, PM3021, PM3222) · Smart Cache III (PM2?3?) · Smart RAID III (PM3?3?, PM3332 [EISA], PM3334UW [PCI]) (Gen3) · Smart Cache IV (PM2?4?, PM2042 [EISA], PM2044/PM2144 [PCI]) (Gen4) · Smart RAID IV
The dpt driver first appeared in FreeBSD 2.2.6.
The dpt driver was written by Simon Shapiro and ported to the CAM SCSI system by Justin T. Gibbs.