Provided by: freebsd-manpages_10.1~RC1-1_all bug

NAME

     ex — Ethernet device driver for the Intel EtherExpress Pro/10 and Pro/10+

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel
     configuration file:

           device ex

     Alternatively, to load the driver as a module at boot time, place the following line in
     loader.conf(5):

           if_ex_load="YES"

DESCRIPTION

     The ex driver provides support for Ethernet adapters based on the Intel i82595 chip.

     On the ISA bus, the card will be searched for in the I/O address range 0x200 - 0x3a0.  The
     IRQ will be read from the EEPROM on the card.  For correct operation Plug-N-Play support
     should be disabled.

     On the PC Card bus, the card will be automatically recognized and configured.

HARDWARE

     The ex driver supports the following Ethernet adapters:

     ·   Intel EtherExpress Pro/10 ISA
     ·   Intel EtherExpress Pro/10+ ISA
     ·   Olicom OC2220 Ethernet PC Card
     ·   Olicom OC2232 Ethernet/Modem PC Card
     ·   Silicom Ethernet LAN PC Card
     ·   Silicom EtherSerial LAN PC Card

DIAGNOSTICS

     ex%d: Intel EtherExpress Pro/10, address %6D, connector %s  The device probe found an
     installed card, and was able to correctly install the device driver.

     ex%d: WARNING: board's EEPROM is configured for IRQ %d, using %d  The device probe detected
     that the board is configured for a different interrupt than the one specified in the kernel
     configuration file.

     ex%d: invalid IRQ.  The device probe detected an invalid IRQ setting.

SEE ALSO

     arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

     The ex device driver first appeared in FreeBSD 2.2.

AUTHORS

     The ex device driver was written by Javier Martín Rueda.  The PC Card attachment was written
     by Mitsuru ISAWAKI and Warner Losh.  This manual page was written by David E. O'Brien.

BUGS

     Currently the driver does not support multicast.

     The Silicom EtherSerial card's serial port does not currently work.  The Olicom OC2232 PC
     Card should work with the ex driver, but is currently completely broken.