Provided by: freebsd-manpages_10.1~RC1-1_all
rc — RISCom/8 multiport card
device isa device rc
The RISCom/8 is an eight port ISA RS-232C communications multiplexer with a built in RISC processor. It uses a block of sixteen I/O ports in the range 0x200 to 0x3f0 selectable by on-board switches or jumpers. The block must be aligned on a sixteen port boundary. The jumper-selectable hardware interrupt level may be set to be detected during system initialization using settings found in the /boot/device.hints file. This driver is mostly based on the Cirrus Logic CL-CD180 driver.
The rc driver provides support for the SDL Communications RISCom/8 boards.
The following driver specific error messages may be reported: rc%d channel%d: interrupt-level buffer overflow An internal buffer overflow error has occurred on the listed channel. The rc driver will need to be reloaded to correct this. rc%d: Bad char chan %d The channel has obtained a bad set of characters. rc%d: Got extra chars chan %d The rc driver got more characters than expected on the channel shown. rc%d: data mismatch chan %d ptr %d (%d != %d) Data sent from channel %d to the rx buffer was different then expected. rc%d: channel %d command timeout, rc.c line: %d A command timeout has occurred on the channel, the src/sys/dev/rc/rc.c file can be consulted for more information.
tty(1), ttyname(3), sio(4), tty(4), device.hints(5), comcontrol(8), getty(8), mutex(9), splx(9) http://www.sdlcomm.com
The rc driver first appeared in FreeBSD 2.0.5. This manual page first appeared in FreeBSD 5.3.
This manual page was written by Tom Rhodes <trhodes@FreeBSD.org>.