Provided by: inn2_2.6.0-2_amd64 bug


       innwatch - Monitor the state of INN and the system


       innwatch [-f ctlfile] [-i seconds] [-l logfile] [-t seconds]


       innwatch is normally started by  Every innwatchsleeptime seconds, as set in
       inn.conf, it examines the load average, and the number of free blocks and inodes on the
       spool partition, as described by its control file, innwatch.ctl in pathetc.

       If the load gets too high, or the disk gets too full, it throttles the server.  When the
       condition restores, it unblocks the server.  In addition, on each pass through the loop,
       it will check the logfile pathlog/news.crit to see if it has been modified, and send mail
       to the news administrator if so.

       Upon receipt of an interrupt signal (SIGINT), innwatch will report its status in the file
       innwatch.status in pathrun.


       -f file
           Specify the control file to use, other than the default of innwatch.ctl in pathetc.

       -i seconds
           With this option, innwatch has an initial sleep of seconds seconds at startup.  This
           is useful when innwatch is started at the same time as INN, so that it can wait a
           little before beginning performing its checks.

       -l logfile
           Specify a log file to watch, other than the default of news.crit.

       -t seconds
           Specify the period in seconds between checks, to override the value set in inn.conf.


       Written by Mike Cooper <>, with modifications by <>, Steve
       Groom <> and Christophe Wolfhugel <>.  Converted to
       POD by Julien Elie.

       $Id: innwatch.pod 9722 2014-09-24 17:47:12Z iulius $


       inn.conf(5), innwatch.ctl(5), newslog(5),