Provided by: micro-httpd_20051212-15_amd64
micro-httpd - really small HTTP server
micro-httpd is a very small HTTP server all in 150 lines of code. It runs from inetd, which means its performance is poor. But for low-traffic sites, it is quite adequate. It implements all the basic features of an HTTP server, including: * Security against ".." filename snooping. * The common MIME types. * Trailing-slash redirection. * index.html * Directory listings. To install it, add a line like this to /etc/inetd.conf: micro-http stream tcp nowait nobody \ /usr/sbin/micro-httpd micro-httpd dir Make sure the path to the executable is correct, and change "dir" to be the directory you want to serve. You could add line like this to /etc/services: micro-http port/tcp #Micro HTTP server Change "port" to the port number you want to use: 80, 8000, whatever. Restart inetd by sending it a "HUP" signal. On some systems, inetd has a maximum spawn rate - if you try to run inetd services faster than a certain number of times per minute, it assumed there is either a bug of an attack going on and it shuts down for a few minutes. If you run into this problem - look for syslog messages about too-rapid looping - you will need to find out how to increase the limit. Unfortunately this varies from OS to OS. On FreeBSD, you add a "-R 10000" flag to inetd's initial command line. On some Linux systems, you can set the limit on a per- service basis in inetd.conf, by changing "nowait" to "nowait.10000". Note that you can use micro-httpd to serve HTTPS, if you like, by running it from stunnel. First fetch and install stunnel - FreeBSD users can just go to /usr/ports/security/stunnel and do a "make cert ; make install". Then as root run: stunnel -p /usr/local/certs/stunnel.pem -d 443 -l \ /usr/sbin/micro-httpd -- micro-httpd dir Make sure the paths to the certificate and executable are correct, and again don not forget to change "dir" to the directory you want to serve.
inetd(8) micro-inetd(8) xinetd(8)
Copyright (C) 1999 Jef Poskanzer <email@example.com>. All rights reserved. This manual page was updated by Jari Aalto <firstname.lastname@example.org>. Released under license GNU GPL v2 or (at your option) any later version. For more information about license, visit <http://www.gnu.org/copyleft/gpl.html>.