NAME

     ubsa — USB support for Belkin serial adapters

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel configuration file:

           device usb
           device ucom
           device ubsa

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

           ubsa_load="YES"

DESCRIPTION

     The ubsa driver provides support for the USB-to-RS232 Bridge chip used by a variety of serial adapters from
     Belkin and other vendors.

     The device is accessed through the ucom(4) driver which makes it behave like a tty(4).

HARDWARE

     The ubsa driver supports the following adapters:

     •   AnyData ADU-500A EV-DO modem
     •   AnyData ADU-E100A (no EV-DO mode support)
     •   Belkin F5U103
     •   Belkin F5U120
     •   e-Tek Labs Kwik232
     •   GoHubs GoCOM232
     •   Peracom single port serial adapter

FILES

     /dev/ttyU*       for callin ports
     /dev/ttyU*.init
     /dev/ttyU*.lock  corresponding callin initial-state and lock-state devices

     /dev/cuaU*       for callout ports
     /dev/cuaU*.init
     /dev/cuaU*.lock  corresponding callout initial-state and lock-state devices

SEE ALSO

     tty(4), ucom(4), usb(4)

HISTORY

     The ubsa driver appeared in FreeBSD 5.0.  The uplcom(4) manual page was adopted from NetBSD by Tom Rhodes
     <trhodes@FreeBSD.org> in April 2002 and modified for the ubsa driver by Alexander Kabaev <kan@FreeBSD.org>
     in October 2002.

AUTHORS

     The ubsa driver was written by Alexander Kabaev <kan@FreeBSD.org>.