NAME

       systemd-veritysetup-generator - Unit generator for integrity protected block devices

SYNOPSIS

       /lib/systemd/system-generators/systemd-veritysetup-generator

DESCRIPTION

       systemd-veritysetup-generator is a generator that translates kernel command line options
       configuring integrity protected block devices (verity) into native systemd units early at
       boot and when configuration of the system manager is reloaded. This will create systemd-
       veritysetup@.service(8) units as necessary.

       Currently, only a single verity device may be se up with this generator, backing the root
       file system of the OS.

       systemd-veritysetup-generator implements systemd.generator(7).

KERNEL COMMAND LINE

       systemd-veritysetup-generator understands the following kernel command line parameters:

       systemd.verity=, rd.systemd.verity=
           Takes a boolean argument. Defaults to "yes". If "no", disables the generator entirely.
           rd.systemd.verity= is honored only by the initial RAM disk (initrd) while
           systemd.verity= is honored by both the host system and the initrd.

       roothash=
           Takes a root hash value for the root file system. Expects a hash value formatted in
           hexadecimal characters, of the appropriate length (i.e. most likely 256 bit/64
           characters, or longer). If not specified via systemd.verity_root_data= and
           systemd.verity_root_hash=, the hash and data devices to use are automatically derived
           from the specified hash value. Specifically, the data partition device is looked for
           under a GPT partition UUID derived from the first 128bit of the root hash, the hash
           partition device is looked for under a GPT partition UUID derived from the last 128bit
           of the root hash. Hence it is usually sufficient to specify the root hash to boot from
           an integrity protected root file system, as device paths are automatically determined
           from it — as long as the partition table is properly set up.

       systemd.verity_root_data=, systemd.verity_root_hash=
           These two settings take block device paths as arguments, and may be use to explicitly
           configure the data partition and hash partition to use for setting up the integrity
           protection for the root file system. If not specified, these paths are automatically
           derived from the roothash= argument (see above).

SEE ALSO

       systemd(1), systemd-veritysetup@.service(8), veritysetup(8), systemd-fstab-generator(8)