Provided by: dnet-progs_2.65_amd64 
NAME
dnroute - DECnet Routing Daemon
SYNOPSIS
dnroute [options]
Options:
[-dvV2Dtnhr]
DESCRIPTION
dnroute is a daemon that manages the DECnet routing tables to provide a simple
but probably useful routing policy.
dnroute listens for incoming routing messages and adds routes in the kernel for non-local areas that it
sees. Routes will be modifed according to these messages so that the lowest cost route that is up will
always be used. Routes to locally accessible nodes (it those in the neighbour table) will also be added.
If you want to keep manual control of the route to a particular area, then add a line into dnroute.conf.
eg:
manual 26
will disable dnroute's setting of routing tables for that area. dnetinfo will still show the route that
would have been set with (M) on the line to show it has been overidden.
To implement its routing policies dnroute assumes that all interfaces on the system have a cost of 4. To
change this add lines in /etc/dnroute.conf for each of the interfaces you need to change. eg
eth0 6
eth1 8
tap0 10
A script called dnetinfo is provided that gets the routing information from dnroute and displays it on
stdout in a format similar to the VMS command SHOW NET/OLD.
OPTIONS
-d Don't fork and run the background. Use this for debugging.
-v Verbose. Log route changes to syslog.
-D Debug log. Writes debugging information to stderr. Only useful with -d.
-h -? Displays help for using the command.
-r Send DECnet routing messages showing the state of local nodes.
-2 Send DECnet level 2 (area) routing messages. Implies -r.
-t <secs>
Timer to send routing messages on. Defaults to 15 seconds.
-n Do not set up routes or send routing messages, just monitor the network. Useful for testing.
-V Show the version of dnroute.
SEE ALSO
dnetd.conf(5), ip(8)