NAME

       mConcatFit - Merge multiple plane fit parameter files into one file

SYNOPSIS

       mConcatFit [-d] [-s statusfile] statfiles.tbl fits.tbl statdir

DESCRIPTION

       Merge  multiple plane fit parameter files (from mFitplane) into one file. This module is only needed in a
       Grid environment where the mFitplane jobs may run in parallel on computers  that  do  not  share  a  file
       system. In this case, the fit parameters have to be merged into one file before mBgModel can be called.

BUGS

       This  module  have  been used extensively but have not been subject to the same rigorous testing to which
       the core modules have been subjected. We  advise  users  to  contact  Montage  (montage@ipac.caltech.edu)
       before employing them to verify limitations in their use and changes in the interfaces.

COPYRIGHT

       2001-2014 California Institute of Technology, Pasadena, California

       If  your  research uses Montage, please include the following acknowledgement: "This research made use of
       Montage. It is funded by the  National  Science  Foundation  under  Grant  Number  ACI-1440620,  and  was
       previously funded by the National Aeronautics and Space Administration's Earth Science Technology Office,
       Computation Technologies Project, under Cooperative  Agreement  Number  NCC5-626  between  NASA  and  the
       California Institute of Technology."

       The  Montage  distribution includes an adaptation of the MOPEX algorithm developed at the Spitzer Science
       Center.