Provided by: fdutils_5.5-20060227-8_amd64 bug

Name

       setfdprm - sets user-provided floppy disk parameters

Note

       This  manpage  has  been  automatically  generated  from  fdutils's texinfo documentation.
       However, this process is only approximative, and some  items,  such  as  cross-references,
       footnotes  and  indices are lost in this translation process.  Indeed, these items have no
       appropriate representation in the manpage format.  Moreover, only the  items  specific  to
       each  command  have  been  translated,  and the general information about fdutils has been
       dropped in the manpage version.  Thus I strongly advise you to use  the  original  texinfo
       doc.

       *      To generate a printable copy from the texinfo doc, run the following commands:

                     ./configure; make dvi; dvips fdutils.dvi

       *      To generate a HTML copy,  run:

                     ./configure; make html

              A pre-made HTML can be found at: `http://www.tux.org/pub/knaff/fdutils'

       *      To generate an info copy (browsable using emacs' info mode), run:

                     ./configure; make info

       The  texinfo  doc  looks most pretty when printed or as HTML.  Indeed, in the info version
       certain examples are difficult to read due to the quoting conventions used in info.

Description

          setfdprm [-p] device media-description

          setfdprm [-c | -y | -n] device

       setfdprm is a utility that can be used to load disk  parameters  into  the  auto-detecting
       floppy  devices  and  "fixed parameter" floppy devices, to clear old parameter sets and to
       disable or enable diagnostic  messages.   These  parameters  are  derived  from  a  media-
       description, see section  Media description for more details.

       Without any options, setfdprm loads the device (for example `/dev/fd0' or `/dev/fd1') with
       a new parameter set with the name entry found in `/etc/mediaprm' (usually  named  360/360,
       etc.).   For autodetecting floppy devices, these parameters stay in effect until the media
       is changed. For "fixed parameter" devices, they stay in  effect  until  they  are  changed
       again.

       Setfdprm can also be used by the superuser to redefine the default formats.

Options

       -p device name
              Permanently  loads  a  new  parameter set for the specified auto-configuring floppy
              device for the configuration  with  name  in  `/etc/mediaprm'.  Alternatively,  the
              parameters can be given directly from the command line.

       -c device
              Clears the parameter set of the specified auto-configuring floppy device.

       -y device
              Enables format detection messages for the specified auto-configuring floppy device.

       -n device
              Disables  format  detection  messages  for  the  specified  auto-configuring floppy
              device.

Media description

       Please see the Media description section in the full fdutils documentation:
       - Texinfo documentation (info fdutils)
       - HTML documentation in /usr/share/doc/fdutils/Fdutils.html
       - or DVI documentation in /usr/share/doc/fdutils/Fdutils.dvi.gz

Bugs

       This documentation is grossly incomplete.

See Also

       Fdutils' texinfo doc