NAME

       myson-diag - EEPROM setup and diagnostic program for ethernet cards based on the Myson MTD803 chip.

SYNOPSIS

       myson-diag [options]

DESCRIPTION

       myson-diag  is  a  program  that  you can use to diagnose problems with ethernet cards based on the Myson
       MTD803 chip.

OPTIONS

       These programs follow the usual GNU command line syntax, with  long  options  starting  with  two  dashes
       (`-').  A summary of options is included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -q, --quiet
              Be very unverbose.

       -# <cardnum>
              Use card number <cardnum>.

       -a, --show_all_registers
              Print all registers.

       -e, --show-eeprom
              Dump EEPROM contents to stdout.

       -E, --emergency-rewrite
              Re-write a corrupted EEPROM.

       -p, --port-base <port>
              Specify port to use.

       -A, --Advertise <mediaype>
              Advertise  media  type. Valid Options are: 10baseT, 100baseT4, 100baseTx, 100baseTx-FD, 100baseTx-
              HD, 10baseT-FD and 10baseHD.

       -F, --new-interface <interface>
              Interface number. Options that make sense are:  10baseT,  10base2,  AUI,  100baseTx,  10baseT-FDX,
              100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense.

       -H, --new-hwaddress <address>
              Set card to a new hardware address.

       -m, --show-mii
              Dump MII management registers.

       -R, --reset
              Reset the transceiver.

       -T, --test
              Do register and SRAM test.

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values. Do not use this, if you do not know what you do!

       -f, --force-detection
              Try to identify the card, even if it is active.

       -t, --chip-type <card>
              Explicitly set the chip. To get all valid numbers, run myson-diag with the options '-t -1'.

SEE ALSO

       mii-diag(8)

AUTHOR

       myson-diag was written and is still maintained by Donald Becker <becker@scyld.com>.  This manual page was
       written  by  Alain  Schroeder  <alain@debian.org>,  for  the  Debian GNU/Linux system (but may be used by
       others).

                                                February 18, 2002                                  MYSON-DIAG(8)