NAME

     ce — driver for synchronous Cronyx Tau-PCI/32 WAN adapters

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel configuration file:

           device ce

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

           if_ce_load="YES"

     Additional options:
     device sppp
     options NETGRAPH
     options NETGRAPH_CRONYX

DESCRIPTION

     The ce driver needs either sppp(4) or netgraph(4).  Which one to use is determined by the NETGRAPH_CRONYX
     option.  If this option is present in your kernel configuration file, the ce driver will be compiled with
     netgraph(4) support.  Otherwise, it will be compiled with sppp(4) support.

     Refer to sconfig(8) for information about the ce adapter configuration.

HARDWARE

     The ce driver supports the following models of Tau-PCI/32 WAN adapters:

     Cronyx Tau-PCI/32     two fractional/unframed E1 interfaces, with 32 HDLC channels shared between them with
                           total adapter throughput 2048 kbps.
     Cronyx Tau-PCI/32-Lite
                           single fractional/unframed E1 interface, with 32 HDLC channels.

SEE ALSO

     cp(4), ctau(4), cx(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)

HISTORY

     The ce driver was added in FreeBSD 6.2, FreeBSD 5.5 and FreeBSD 4.11.  The ce driver for previous versions
     of FreeBSD is available from http://www.cronyx.ru/.