NAME

       /etc/laptop-mode/lm-profiler.conf  -  Configuration  file  for lm-profiler, a profiler for
       laptop-mode-tools.

DESCRIPTION

       This manual page documents the  options  that  can  be  set  in  the  /etc/laptop-mode/lm-
       profiler.conf configuration file.  For a description of what lm-profiler does, see the lm-
       profiler(8) manpage.

SETTINGS

       The syntax of options is OPTION=value.

       The following settings are available in lm-profiler.conf:

       VERBOSE_OUTPUT
                 Set this to 1 if you want to see a lot of output when you run lm-profiler, and 0
                 if you don't want this. Useful for debugging purposes. (Currently does nothing.)

       PROFILE_RUN_LENGTH
                 The  length  of a profiling run, in seconds. This should be a while, so that lm-
                 profiler can gather enough information. The default is 10 minutes (600 seconds).

       ACTIVITY_INTERVAL_MIN

       ACTIVITY_INTERVAL_MAX
                 The behaviour that you want to avoid when you have your hard drive spun down, is
                 disk  accesses  that are spread out over time, because your hard drive will have
                 to spin up for each access. lm-profiler detects when applications  perform  disk
                 accesses  that  are  at  least some time apart (otherwise they can be considered
                 part of the same access) but not TOO far apart (otherwise they are no  problem).
                 These  settings  configure what lm-profiler considers "at least some time apart"
                 and "too far apart", respectively, in seconds.

       RECOMMEND_DEFAULT_SERVICES

       DEFAULT_SERVICES
                 If RECOMMEND_DEFAULT_SERVICES is set  to  1  (enabled),  then  lm-profiler  will
                 always suggest turning off the services listed in DEFAULT_SERVICES (separated by
                 spaces).

       IGNORE_PROGRAMS
                 Programs listed in this option, separated by spaces, will be  ignored  for  disk
                 activity   profiling.   The   default  settings  (which  can  be  referenced  as
                 $DEF_IGNORE_PROGRAMS) include common utility programs and all programs  used  by
                 lm-profiler itself.

       RECOMMEND_NETWORK_SERVICES
                 When this option is enabled (value 1), lm-profiler will detect any services that
                 are listening on network ports, and it will suggest that you disable them.

       IGNORE_NETWORK_SERVICES
                 Services listed in this configuration  option  (separated  by  spaces)  are  not
                 suggested  as  a  network  service  by  lm-profiler.  The  default values can be
                 accessed as $DEF_IGNORE_NETWORK_SERVICES.

SEE ALSO

       lm-profiler(8).

       laptop_mode(8).

       laptop-mode.conf(8).

AUTHOR

       This manual page was written by Bart Samwel (bart@samwel.tk).  Permission  is  granted  to
       copy,  distribute  and/or  modify  this document under the terms of the GNU General Public
       License, Version 2 any later version published by the Free Software Foundation.

                                                                              LM-PROFILER.CONF(8)