NAME

       netctl - Control the netctl network profile manager

SYNOPSIS

       netctl {COMMAND} [PROFILE]

       netctl [--help | --version]

DESCRIPTION

       netctl may be used to introspect and control the state of the systemd services for the
       network profile manager.

OPTIONS

       The following commands are understood:

       list
           List all available profiles. Online profiles will be marked with a ‘*’, otherwise
           active profiles will be marked with a ‘+’.

       store
           Saves which profiles are currently active.

       restore
           Loads the profiles that were active during the last invocation of ‘store’.

       stop-all
           Stops all active network profiles.

       start [PROFILE]
           Start the network profile specified on the command line.

       stop [PROFILE]
           Stop the network profile specified on the command line.

       restart [PROFILE]
           Restart the network profile specified on the command line. If it is not started yet,
           it will be started.

       switch-to [PROFILE]
           Starts the network profile specified on the command line after stopping all profiles
           that refer to the same interface.

       is-active [PROFILE]
           Check whether the network profile specified on the command line is active. Prints the
           current state.

       status [PROFILE]
           Show terse runtime status information about a profile, followed by its most recent log
           data from the journal.

       enable [PROFILE]
           Enable the systemd unit for the profile specified. This will create a unit
           configuration file. If the file already exists, the command fails. No other profiles
           than the one specified will be enabled. Changes to the general options in a profile
           specification will not propagate to the unit configuration file automatically. After
           such changes, it is necessary to ‘reenable’ the profile.

       disable [PROFILE]
           Disable the systemd unit for the profile specified. This will remove the file created
           by ‘enable’ even if it was customized, so be careful.

       reenable [PROFILE]
           Reenable the systemd unit for the profile specified. This is effectively a combination
           of ‘disable’ and ‘enable’.

       is-enabled [PROFILE]
           Check whether the systemd unit for the specified profile is enabled. Prints the
           current enable status.

       edit [PROFILE]
           Open the file of the specified profile in an editor. This does not reenable or restart
           any profiles.

       wait-online [PROFILE]
           Wait until the interface of the profile has a routable IP address of some kind.

EXIT STATUS

       On success 0 is returned, a non-zero failure code otherwise.

ENVIRONMENT

       $NETCTL_DEBUG
           If set to "yes", debugging output is generated.

           The value of this variable is independent of the value of the variable with the same
           name in profiles.

       $NETCTL_STATE_FILE
           The location of the state file. Defaults to /var/lib/netctl/netctl.state.

SEE ALSO

       netctl-auto(1), netctl.profile(5), netctl.special(7), systemctl(1)

                                            01/04/2021                                  NETCTL(1)