Provided by: tstools_1.13~git20151030-5_amd64 bug

NAME

     tsreport — get info about the streams within a transport stream.

SYNOPSIS

     tsinfo [-err stdout] [-err stderr] [-verbose | -v] [-timing | -t]
            [-max max_read | -m max_read] [-data] file | -stdin
     tsinfo -buffering | -b [-err stdout] [-err stderr] [-verbose | -v] [-quiet | -q]
            [-max max_read | -m max_read] [-o csv_file [-32]] [-cnt] [-prog prog_no]
            [-tfmt time_format] [-tafmt time_format] file | -stdin
     tsinfo -justpid pid [-err stdout] [-err stderr] [-max max_read | -m max_read] file | -stdin

DESCRIPTION

     Report on the streams in a Transport Stream.  In general the most useful inforation is
     returned by the -b option.

   Common options
     -err stdout
             Write error messages to standard output (the default)

     -err stderr
             Write error messages to standard error (Unix traditional)

     -v, -verbose
             Output extra information about packets

     -q, -quiet
             Output less information

     -m max_scan, -max max_scan
             max_scan is the Number of TS packets to scan. Defaults to the entire file.

     -stdin  Input from standard input, instead of a file

     file    The transport stream file to get info on. If -stdin is specified then no file is
             expected

   -b, -buffering
     Report on the differences between PCR and PTS, and between PCR and DTS. This is relevant to
     the size of buffers needed in the decoder.  Also reports bitrates; the max bitrate is
     calculated over 0.5sec

     -o csv_file [-32]
             Output timing in to a CSV file called csv_file.  If -32 is used as well then the
             timing ifo is restricted to the bottom 32 bits

     -cnt pid
             Check values of continuity_counter for pid pid.  Writes all the values of the
             counter to a file called continuity_counter.txt.

     -prog prog_no
             Report on program prog_no [default = 1] (hopefully default will be 'all' in the
             future)

     -tfmt time_format
             Specify format of time differences.

     -tafmt time_format
             Specify format of absolute times.

             time_format is one of

             90      [Default] show as 90KHz timestamps (suffix 't' on the values: e.g.,
                     4362599t).

             27      Show as 27MHz timestamps (similar, e.g., 25151:000t).

             32      Show as 90KHz timestamps, but only the low 32 bits.

             ms      Show as milliseconds.

             hms     Show as hours/minutes/seconds (H:MM:SS.ssss, the H can be more than one
                     digit if necessary)

   -justpid pid
     Just show data (file offset, index, adaptation field and payload) for TS packets with the
     given PID.  PID 0 is allowed (i.e., the PAT)

SEE ALSO

     tsinfo(1), pcapreport(1)