Provided by: micro-httpd_20140814-2.1_amd64 bug

NAME

       micro-httpd - really small HTTP server

SYNOPSIS

         micro-httpd DIRECTORY

OPTIONS

       None.

DESCRIPTION

       micro-httpd is a very small HTTP server all in 150 lines of code. It runs from inetd,
       which means its performance is poor. But for low-traffic sites, it is quite adequate. It
       implements all the basic features of an HTTP server, including:

           *  Security against ".." filename snooping.
           *  The common MIME types.
           *  Trailing-slash redirection.
           *  index.html
           *  Directory listings.

       To install it, add a line like this to /etc/inetd.conf:

           micro-http  stream tcp nowait nobody \
              /usr/sbin/micro-httpd micro-httpd dir

       Make sure the path to the executable is correct, and change "dir" to be the directory you
       want to serve. You could add line like this to /etc/services:

           micro-http   port/tcp   #Micro HTTP server

       Change "port" to the port number you want to use: 80, 8000, whatever.  Restart inetd by
       sending it a "HUP" signal.

       On some systems, inetd has a maximum spawn rate - if you try to run inetd services faster
       than a certain number of times per minute, it assumed there is either a bug of an attack
       going on and it shuts down for a few minutes. If you run into this problem - look for
       syslog messages about too-rapid looping - you will need to find out how to increase the
       limit. Unfortunately this varies from OS to OS. On FreeBSD, you add a "-R 10000" flag to
       inetd's initial command line. On some Linux systems, you can set the limit on a per-
       service basis in inetd.conf, by changing "nowait" to "nowait.10000".

       Note that you can use micro-httpd to serve HTTPS, if you like, by running it from stunnel.
       First fetch and install stunnel - FreeBSD users can just go to /usr/ports/security/stunnel
       and do a "make cert ; make install". Then as root run:

           stunnel -p /usr/local/certs/stunnel.pem -d 443 -l \
              /usr/sbin/micro-httpd --  micro-httpd dir

       Make sure the paths to the certificate and executable are correct, and again don not
       forget to change "dir" to the directory you want to serve.

ENVIRONMENT

       None.

FILES

       None.

SEE ALSO

       inetd(8) micro-inetd(8) xinetd(8)

AUTHORS

       Copyright (C) 1999 Jef Poskanzer <jef@mail.acme.com>. All rights reserved.

       This manual page was updated by Jari Aalto <jari.aalto@cante.net>.  Released under license
       GNU GPL v2 or (at your option) any later version. For more information about license,
       visit <http://www.gnu.org/copyleft/gpl.html>.