Provided by: libmodbus-dev_3.1.6-2_amd64 bug

NAME

       modbus_set_error_recovery - set the error recovery mode

SYNOPSIS

       int modbus_set_error_recovery(modbus_t *ctx, modbus_error_recovery_mode error_recovery);

DESCRIPTION

       The modbus_set_error_recovery() function shall set the error recovery mode to apply when
       the connection fails or the byte received is not expected. The argument error_recovery may
       be bitwise-or’ed with zero or more of the following constants.

       By default there is no error recovery (MODBUS_ERROR_RECOVERY_NONE) so the application is
       responsible for controlling the error values returned by libmodbus functions and for
       handling them if necessary.

       When MODBUS_ERROR_RECOVERY_LINK is set, the library will attempt an reconnection after a
       delay defined by response timeout of the libmodbus context. This mode will try an infinite
       close/connect loop until success on send call and will just try one time to re-establish
       the connection on select/read calls (if the connection was down, the values to read are
       certainly not available any more after reconnection, except for slave/server). This mode
       will also run flush requests after a delay based on the current response timeout in some
       situations (eg. timeout of select call). The reconnection attempt can hang for several
       seconds if the network to the remote target unit is down.

       When MODBUS_ERROR_RECOVERY_PROTOCOL is set, a sleep and flush sequence will be used to
       clean up the ongoing communication, this can occurs when the message length is invalid,
       the TID is wrong or the received function code is not the expected one. The response
       timeout delay will be used to sleep.

       The modes are mask values and so they are complementary.

       It’s not recommended to enable error recovery for slave/server.

RETURN VALUE

       The function shall return 0 if successful. Otherwise it shall return -1 and set errno to
       one of the values defined below.

ERRORS

       EINVAL
           The value of the argument error_recovery is not positive.

EXAMPLE

           modbus_set_error_recovery(ctx,
                                     MODBUS_ERROR_RECOVERY_LINK |
                                     MODBUS_ERROR_RECOVERY_PROTOCOL);

AUTHORS

       The libmodbus documentation was written by Stéphane Raimbault
       <stephane.raimbault@gmail.com>