Provided by: freebsd-manpages_12.2-1_all
umass — USB Mass Storage Devices driver
To compile this driver into the kernel, place the following line in your kernel configuration file: device scbus device usb device umass Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): umass_load="YES"
The umass driver provides support for Mass Storage devices that attach to the USB port. To use the umass driver, usb(4) and one of uhci(4) or ohci(4) or ehci(4) or xhci(4) must be configured in the kernel. Additionally, since umass uses the SCSI subsystem and sometimes acts as a SCSI device, it requires da(4) and scbus(4) to be included in the kernel.
device umass device scbus device da device pass Add the umass driver to the kernel. camcontrol rescan 0:0:0 camcontrol rescan 0:0:1 camcontrol rescan 0:0:2 camcontrol rescan 0:0:3 Rescan all slots on a multi-slot flash reader, where the slots map to separate LUNs on a single SCSI ID. Typically only the first slot will be enabled at boot time. This assumes that the flash reader is the first SCSI bus in the system and has 4 slots.
The umass driver was written by MAEKAWA Masahide <email@example.com> and Nick Hibma <n_hibma@FreeBSD.org>. This manual page was written by Nick Hibma <n_hibma@FreeBSD.org>.