Provided by: freebsd-manpages_12.2-1_all
uvscom — USB support for SUNTAC Slipper U VS-10U serial adapters driver
To compile this driver into the kernel, place the following lines in your kernel configuration file: device usb device ucom device uvscom Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): uvscom_load="YES"
The uvscom driver supports the following adapters: • DDI Pocket Air H" C@rd • DDI Pocket Air H" C@rd 64 • NTT P-in • NTT P-in m@ster
The uvscom driver provides support for the SUNTAC Slipper U VS-10U chip. Slipper U is a PC Card to USB converter for data communication card adapters. The device is accessed through the ucom(4) driver which makes it behave like a tty(4).
/dev/ttyU* for callin ports /dev/ttyU*.init /dev/ttyU*.lock corresponding callin initial-state and lock-state devices /dev/cuaU* for callout ports /dev/cuaU*.init /dev/cuaU*.lock corresponding callout initial-state and lock-state devices
The uvscom driver first appeared in FreeBSD and later in NetBSD 1.6. This manual page was adopted from NetBSD by Tom Rhodes <trhodes@FreeBSD.org> in April 2002.