Provided by: snek_1.9-1_all bug

NAME

       snek-lilypad-big-big-install - Install larger version of Snek to Arduino ATmega328 board

SYNOPSIS

       snek-lilypad-big-install [OPTION]... [COMMAND]

DESCRIPTION

       snek-lilypad-big-install  installs  the  larger  version  Snek  programming language on an
       Arduino board with an ATmega328,  overwriting  the  boot  loader.  This  version  of  snek
       provides  support for a few extra functions, 'input', 'float' and 'int'. As a consequence,
       it does not leave room for the Optiboot loader  and  must  be  flashed  using  a  separate
       programmer dongle.

OPTIONS

       -isp <ISP model>
              Specifies  the  programmer  to use, common options are 'usbtiny' and 'avrisp2'. The
              default is 'usbtiny'.

       -hex <snek.hex>
              Specifies the hex file to load to the board. The default is the currently installed
              version of Snek.

       -mcu <MCU name>
              Specifies  which  micro controller to expect to find on the board. Some boards have
              m328 while others have m328p. The default is m328p, but if you get an error message
              indicating a mismatch, you can try the other.

COMMANDS

       fuseload
              Sets the target fuse bits for Snek usage and then loads Snek to the device. This is
              the default command

       load   Loads Snek to the device without first setting the fuse bits. Snek  will  not  work
              correctly if the fuse bits are not set correctly, so only do this if the target has
              already had the fuse bits set correctly.

       fuse   Sets the target fuse bits suitable for Snek usage. You must  do  this  before  Snek
              will  work on the target device, although you may do it before or after loading the
              Snek system. You only need to do this once per board.

AUTHOR

       Keith Packard

                                     snek-lilypad-big-install         SNEK-LILYPAD-BIG-INSTALL(1)