NAME

       dlt_gateway.conf - DLT configuration file for gateway

DESCRIPTION

       The  configuration  file  dlt_gateway.conf  allows  to  configure  the  different  runtime
       behaviour of gateway in Multinode feature.

       The configuration file is written in an INI file format  and  contains  information  about
       different connected passive nodes.

       If  Multinode  feature  is  enabled,  dlt-daemon  loads  by default the configuration file
       /etc/dlt_gateway.conf.

       An  alternative  configuration  file  can  be  loaded  by  changing  GatewayConfigFile  in
       dlt.conf(5).

GENERAL SECTION

   Interval
       Time interval for reconnection to passive Node in second.

              Default: 1

PASSIVENODE SECTION

       Each  passive  node’s  connection  parameters  are specified in a unique numbered separate
       section

       ([PassiveNode{1,2, ...N}]).

              Example: [PassiveNode1]

   IPaddress
       Because TCP is the only supported communication channel,

       the IPaddress and Port of the Passive DLT Daemon has to be specified.

       IP Address of passive node.  Mandatory

   Port
       TCP port.  Default 3490 is used if no port is specified.

              Default: 3490

   EcuID
       ECU identifier of passive node.  Mandatory.

   Connect
       With the Connect property it is possible to specify when  the  Gateway  DLT  Daemon  shall
       connect to the passive node.

              Default: OnStartUp

       The following values are allowed:

              OnStartup   The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
                          immediately after the Gateway DLT Daemon is started.
              OnDemand    The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
                          when it receives a connection request.

   Timeout
       Stop connecting to passive node, if not successful after 10 retries.

       After of retries, the connection to passive Node is marked as DISABLED.

       It means there is no any retry anymore.

       Set to 0 for endless retry.

              Default: 10

   SendControl
       Send following control messages after connection is established.  Optional.

              Default: disabled

       Supported Control messages:

              DLT_SERVICE_ID_GET_LOG_INFO                    0x03
              DLT_SERVICE_ID_GET_DEFAULT_LOG_LEVEL           0x04
              DLT_SERVICE_ID_GET_SOFTWARE_VERSION            0x13

   SendSerialHeader
       Send  Serial Header with control messages.  Value in dlt.conf(5) is used as default if not
       specified.

              Default: disabled

   SendPeriodicControl
       Send following control messages periodically.

              Default: disabled

       Format:

              control:interval[in seconds]

AUTHOR

       Thanh Bui Nguyen Quoc (thanh.buinguyenquoc (at) vn (dot) bosch (dot) vn)

COPYRIGHT

       Copyright (C) 2020 Advanced Driver  Information  Technology,  Bosch  and  DENSO.   License
       MPL-2.0: Mozilla Public License version 2.0 http://mozilla.org/MPL/2.0/.

BUGS

       See Github issue: <https://github.com/GENIVI/dlt-daemon/issues>

SEE ALSO

       dlt.conf(5), dlt-daemon(1)

                                                                              DLT_GATEWAY.CONF(5)