NAME

       tripplite - Driver for Tripp-Lite SmartPro UPS equipment

NOTE

       This man page only documents the hardware-specific features of the tripplite driver. For
       information about the core driver, see nutupsdrv(8).

SUPPORTED HARDWARE

       This driver should work on the SmartPro line, including the SMART700 and SMART700SER. It
       only supports SmartPro models that communicate using the serial port.

EXTRA ARGUMENTS

       This driver supports the following optional settings in the ups.conf(5):

       offdelay=num
           Time to wait before the UPS is turned off after the kill power command is sent. The
           default value is 64 (in seconds).

       rebootdelay=num
           Set the timer before the UPS is cycled after the reboot command is sent. The default
           value is 64 (in seconds).

       startdelay=num
           Set the time that the UPS waits before it turns itself back on after a reboot command.
           The default value is 60 (in seconds).

KNOWN ISSUES AND BUGS

       Battery charge information may not be correct for all UPSes. It is tuned to be correct for
       a SMART700SER. Other models may not provide correct information. Information from the
       manufacturer would be helpful.

AUTHORS

       •   Rickard E. (Rik) Faith

       •   Nicholas Kain

SEE ALSO

   The core driver:
       nutupsdrv(8)

   Other drivers for Tripp-Lite hardware:
       tripplitesu(8), tripplite_usb(8), usbhid-ups(8)

   Internet resources:
       The NUT (Network UPS Tools) home page: http://www.networkupstools.org/