Provided by: zfsutils-linux_2.1.9-2ubuntu1_amd64 bug

NAME

     zpool-scrub — begin or resume scrub of ZFS storage pools

SYNOPSIS

     zpool scrub [-s|-p] [-w] pool

DESCRIPTION

     Begins a scrub or resumes a paused scrub.  The scrub examines all data in the specified
     pools to verify that it checksums correctly.  For replicated (mirror, raidz, or draid)
     devices, ZFS automatically repairs any damage discovered during the scrub.  The zpool status
     command reports the progress of the scrub and summarizes the results of the scrub upon
     completion.

     Scrubbing and resilvering are very similar operations.  The difference is that resilvering
     only examines data that ZFS knows to be out of date (for example, when attaching a new
     device to a mirror or replacing an existing device), whereas scrubbing examines all data to
     discover silent errors due to hardware faults or disk failure.

     Because scrubbing and resilvering are I/O-intensive operations, ZFS only allows one at a
     time.

     A scrub is split into two parts: metadata scanning and block scrubbing.  The metadata
     scanning sorts blocks into large sequential ranges which can then be read much more
     efficiently from disk when issuing the scrub I/O.

     If a scrub is paused, the zpool scrub resumes it.  If a resilver is in progress, ZFS does
     not allow a scrub to be started until the resilver completes.

     Note that, due to changes in pool data on a live system, it is possible for scrubs to
     progress slightly beyond 100% completion.  During this period, no completion time estimate
     will be provided.

OPTIONS

     -s  Stop scrubbing.

     -p  Pause scrubbing.  Scrub pause state and progress are periodically synced to disk.  If
         the system is restarted or pool is exported during a paused scrub, even after import,
         scrub will remain paused until it is resumed.  Once resumed the scrub will pick up from
         the place where it was last checkpointed to disk.  To resume a paused scrub issue zpool
         scrub again.

     -w  Wait until scrub has completed before returning.

EXAMPLES

     Example 1: Status of pool with ongoing scrub:
           Output:
                 # zpool status
                   ...
                   scan: scrub in progress since Sun Jul 25 16:07:49 2021
                         403M scanned at 100M/s, 68.4M issued at 10.0M/s, 405M total
                         0B repaired, 16.91% done, 00:00:04 to go
                   ...
           Where:

                 -   Metadata which references 403M of file data has been scanned at 100M/s, and
                     68.4M of that file data has been scrubbed sequentially at 10.0M/s.

PERIODIC SCRUB

     On machines using systemd, scrub timers can be enabled on per-pool basis.  weekly and
     monthly timer units are provided.

             systemctl enable zfs-scrub-weekly@rpool.timer --now

             systemctl enable zfs-scrub-monthly@otherpool.timer --now

SEE ALSO

     systemd.timer(5), zpool-iostat(8), zpool-resilver(8), zpool-status(8)