NAME

       rs274 - standalone G-code interpreter

SYNOPSIS

       rs274 [-p interp.so] [-t tool.tbl] [-v var-file.var] [-n 0|1|2]
                 [-b] [-s] [-g] [input file [output file]]

DESCRIPTION

       rs274 Standalone G-code interpreter interface

       Usage: rs274 [-p interp.so] [-t tool.tbl] [-v var-file.var] [-n 0|1|2]
                 [-b] [-s] [-g] [input file [output file]]

           -p: Specify the pluggable interpreter to use
           -t: Specify the .tbl (tool table) file to use
           -v: Specify the .var (parameter) file to use
           -n: Specify the continue mode:
                  0: continue
                  1: enter MDI mode
                  2: stop (default)
           -b: Toggle the 'block delete' flag (default: OFF)
           -s: Toggle the 'print stack' flag (default: OFF)
           -g: Toggle the 'go (batch mode)' flag (default: OFF)
           -i: specify the .ini file (default: no ini file)
           -T: call task_init()
           -l: specify the log_level (default: -1)

Example

       To  see  the  output  of a loop for example we can run rs274 on the following file and see
       that the loop never ends. To break out of the loop use Ctrl Z. The following two files are
       needed to run the example.

       test.ngc
        ----
        #<test> = 123.352
        o101 while [[#<test> MOD 60 ] NE 0]
        (debug,#<test>)
           #<test> = [#<test> + 1]
        101 endwhile
        M2
        ----

       test.tbl
        ----
        T1 P1 Z0.511 D0.125 ;1/8 end mill
        T2 P2 Z0.1 D0.0625 ;1/16 end mill
        T3 P3 Z1.273 D0.201 ;#7 tap drill
        ----

       command
        ----
        rs274 -g test.ngc -t test.tbl
        ----

SEE ALSO

       LinuxCNC(1)

       Much  more  information  about  LinuxCNC and HAL is available in the LinuxCNC and HAL User
       Manuals, found at /usr/share/doc/LinuxCNC/.

BUGS

       None known at this time.

AUTHOR

       This man page written by andypugh, as part of the LinuxCNC project.

REPORTING BUGS

       Report bugs at https://github.com/LinuxCNC/linuxcnc/issues

COPYRIGHT

       Copyright © 2020 andypugh.
       This is free software; see the source for copying conditions.  There is NO  warranty;  not
       even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.