NAME

       snek-duemilanove-big-big-install  -  Install  larger  version of Snek to Arduino ATmega328
       board

SYNOPSIS

       snek-duemilanove-big-install [OPTION]... [COMMAND]

DESCRIPTION

       snek-duemilanove-big-install installs the larger version Snek programming language  on  an
       Arduino  board  with  an  ATmega328,  overwriting  the  boot  loader. This version of snek
       provides support for a few extra functions, 'input', 'float' and 'int'. As a  consequence,
       it  does  not  leave  room  for  the  Optiboot loader and must be flashed using a separate
       programmer dongle.

OPTIONS

       -isp <ISP model>
              Specifies the programmer to use, common options are 'usbtiny'  and  'avrisp2'.  The
              default is 'usbtiny'.

       -hex <snek.hex>
              Specifies the hex file to load to the board. The default is the currently installed
              version of Snek.

       -mcu <MCU name>
              Specifies which micro controller to expect to find on the board. Some  boards  have
              m328  while others have m328p. The default is m328, but if you get an error message
              indicating a mismatch, you can try the other.

COMMANDS

       fuseload
              Sets the target fuse bits for Snek usage and then loads Snek to the device. This is
              the default command

       load   Loads  Snek  to  the device without first setting the fuse bits. Snek will not work
              correctly if the fuse bits are not set correctly, so only do this if the target has
              already had the fuse bits set correctly.

       fuse   Sets  the  target  fuse  bits suitable for Snek usage. You must do this before Snek
              will work on the target device, although you may do it before or after loading  the
              Snek system. You only need to do this once per board.

AUTHOR

       Keith Packard

                                   snek-duemilanove-big-install   SNEK-DUEMILANOVE-BIG-INSTALL(1)