NAME

       ubertooth-debug - Classic Bluetooth discovery, sniffing, and decoding

SYNOPSIS

              ubertooth-debug -r <number>[,<number>[,...]]

DESCRIPTION

       ubertooth-debug(1) is a tool for reading register values from the CC2400 chip on Ubertooth
       One. It is primarily designed to assist firmware development but may  be  of  interest  to
       curious hackers.

OPTIONS

       Options:

       • -r <reg>[,<reg> [,[...]]] : Read one or more registers from the CC2400 on Ubertooth

       • -r <start>-<end> : Read a consecutive set of registers from the CC2400 on Ubertooth

       • -v <0-2> : Sets the level of verbosity, default is 1.

       • -U<0-7> : Which Ubertooth device to use

EXAMPLES

       To read the MANOR register, use:

              ubertooth-debug -r 19

       Registers can also be specified by name, the following will also read the MANOR register:

              ubertooth-debug -r %manor

       Read a range of registers:

              ubertooth-debug -r 19-22

       Dump all registers with:

              ubertooth-debug -r 0x00-0x70

SEE ALSO

       ubertooth(7): overview of Project Ubertooth

AUTHOR

       This manual page was written by Dominic Spill.

COPYRIGHT

       ubertooth-debug(1)  is  Copyright  (c)  2010-2017.  This tool is released under the GPLv2.
       Refer to COPYING for further details.