Provided by: libconfig-model-lcdproc-perl_2.053-2_all bug

NAME

       Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD

DESCRIPTION

       Configuration classes used by Config::Model

       generated from LCDd.conf

Elements

   Brightness
       Set the initial brightness (4 steps 0-250, 251-500, 501-750, 751-1000)  Optional. Type
       integer.

       upstream_default value :
           1000

   Device
       Device to use in serial mode. Usual values are /dev/ttyS0 and /dev/ttyS1.  Optional. Type
       uniline.

       default value :
           /dev/ttyS1

   ISO_8859_1
       enable ISO 8859 1 compatibility  Optional. Type boolean.

       upstream_default value :
           yes

   OffBrightness
       Set the initial off-brightness This value is used when the display is normally switched
       off in case LCDd is inactive (4 steps 0-250, 251-500, 501-750, 751-1000)  Optional. Type
       integer.

       upstream_default value :
           0

   Port
       Number of Custom-Characters. default is display type dependent Custom-Characters=0
       Portaddress where the LPT is. Used in parallel mode only. Usual values are 0x278, 0x378
       and 0x3BC.  Optional. Type uniline.

       default value :
           0x378

   PortWait
       Set parallel port timing delay (us). Used in parallel mode only.  Optional. Type integer.

       upstream_default value :
           2

   Size
       Specifies the size of the VFD.  Optional. Type uniline.

       default value :
           20x2

   Speed
       set the serial port speed  Optional. Type enum. choice: '1200', '2400', '9600', '19200',
       '115200'.

       upstream_default value :
           9600

   Type
       Specifies the displaytype.  0 NEC (FIPC8367 based) VFDs.  1 KD Rev 2.1.  2 Noritake VFDs
       (*).  3 Futaba VFDs 4 IEE S03601-95B 5 IEE S03601-96-080 (*) 6 Futaba NA202SD08FA (allmost
       IEE compatible) 7 Samsung 20S207DA4 and 20S207DA6 8 Nixdorf BA6x / VT100 (* most should
       work, not tested yet.)  Optional. Type uniline.

       upstream_default value :
           0

   use_parallel
       "no" if display connected serial, "yes" if connected parallel.  I.e. serial by default.
       Optional. Type uniline.

       upstream_default value :
           no

SEE ALSO

       •   cme