NAME

       netctl.special - Special netctl systemd units

SYNOPSIS

       netctl.service, netctl-auto.service, netctl-ifplugd.service, netctl-wait-online.service

DESCRIPTION

       Bundled with netctl come a few systemd units that are not controlled through the netctl
       command. They can be used through the systemctl utility of systemd.

SPECIAL UNITS

       netctl.service
           When started, this unit tries to start the profiles that were running when the unit
           was last stopped. In some cases, the interface a profile binds to might not be
           available yet, when netctl.service tries to bring a profile up. A simple, hackish,
           solution is to do:

           echo "[[ -t 0 ]] || sleep 3" > /etc/netctl/interfaces/<interface>
           chmod 755 /etc/netctl/interfaces/<interface>

           A more concise solution is to first enable a profile through netctl
           and then disable it again through systemctl:

           netctl enable <profile>
           systemctl disable netctl@<profile>

           This way the unit configuration file for the profile remains in
           existence, while the profile is not enabled.

       netctl-sleep.service
           When enabled, this unit stores and stops the active network profiles before the
           machine is put to sleep. After the system is resumed, previously stored profiles are
           restarted.

       netctl-auto@<interface>.service
           This unit issues a scan on the interface it is used for and tries to start a profile
           for a network it finds. It is targeted at wireless interfaces. Profile specific values
           for WPADriver are ignored, but it is possible to specify WPADriver= in an interface
           hook (/etc/netctl/interfaces/<interface>).

           Use netctl-auto(1) instead of netctl(1) to control the automatic profile selection
           when using this unit.

       netctl-ifplugd@<interface>.service
           This unit starts ifplugd on the interface it is used for. It will try to start a
           netctl profile whenever a cable is plugged into the interface and stop the profile
           when the cable is unplugged. Note that this unit does not provide network.target.

       netctl-wait-online.service
           When activated, this unit waits for all enabled netctl profiles to come online.
           Enabling this unit causes network-online.target to only be reached once all enabled
           netctl profiles are fully connected. The maximum time, in seconds, to wait for
           profiles can be passed to this unit via TIMEOUT_ONLINE=. The default value is 120. If
           a timeout occurs, the service enters a failed state.

SEE ALSO

       netctl(1), netctl-auto(1), netctl.profile(5)

                                            08/06/2023                          NETCTL.SPECIAL(7)