NAME

       mlx4en — Mellanox ConnectX-3 10GbE/40GbE network adapter driver

SYNOPSIS

       To compile this driver into the kernel, place these lines in your kernel configuration file:

             options COMPAT_LINUXKPI
             device mlx4
             device mlx4en

       To load the driver as a module at run-time, run this command as root:

             kldload mlx4en

       To load the driver as a module at boot time, place this line in loader.conf(5):

             mlx4en_load="YES"

DESCRIPTION

       Mellanox  ConnectX  adapter cards with Virtual Protocol Interconnect (VPI) provide the highest performing
       and most flexible interconnect solution for Enterprise  Data  Centers,  High-Performance  Computing,  and
       Embedded environments.  Clustered data bases, parallelized applications, transactional services and high-
       performance  embedded  I/O  applications  will  achieve significant performance improvements resulting in
       reduced completion time and lower cost per operation.

HARDWARE

       The mlx4en driver supports the following network adapters:

       •   Mellanox ConnectX-2 (ETH)
       •   Mellanox ConnectX-3 (ETH)

SUPPORT

       For general information and support, go to the Mellanox support website at: http://www.mellanox.com/.

       If an issue is identified with this driver and a supported network adapter,  please  email  the  specific
       information to ⟨freebsd-drivers@mellanox.com⟩.

SEE ALSO

       mlx4ib(4), ifconfig(8)

HISTORY

       The mlx4en device driver first appeared in FreeBSD 9.x.

AUTHORS

       The mlx4en driver was written by Mellanox Technologies <freebsd-drivers@mellanox.com>.

Debian                                            March 1, 2017                                        MLX4EN(4)