NAME

     ubtbcmfw — Firmware driver for Broadcom BCM2033 chip based Bluetooth USB devices

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel configuration file:

           device ubtbcmfw

     Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5):

           ubtbcmfw_load="YES"

DESCRIPTION

     The ubtbcmfw is a firmware driver for Broadcom BCM2033 chip based Bluetooth USB devices.  It provides
     minimal access to the parts of the device required to download firmware.

     The ubtbcmfw driver creates three fixed endpoint device nodes.

     The control transfers can only happen on the control endpoint which is always endpoint 0.  Control requests
     are issued by ioctl(2) calls.

     Only incoming transfers are supported on an interrupt endpoint.  To perform I/O on an interrupt endpoint,
     read(2) should be used.  All I/O operations on an interrupt endpoint are unbuffered.  Interrupt endpoint is
     always endpoint 1.

     Only outgoing bulk transfers are supported on a bulk endpoint.  To perform I/O on a bulk endpoint, write(2)
     should be used.  All I/O operations on a bulk endpoint are unbuffered.  Outgoing bulk endpoint is always
     endpoint 2.

     The control endpoint (endpoint 0) handles the following ioctl(2) calls:

     USB_GET_DEVICE_DESC (usb_device_descriptor_t)
             Return the device descriptor.

FILES

     /dev/ubtbcmfwN.EE  Endpoint EE of device N.

SEE ALSO

     ng_ubt(4), ugen(4), usb(4), bcmfw(8)

HISTORY

     The ubtbcmfw driver was implemented in FreeBSD 5.0.

AUTHORS

     Maksim Yevmenkin <m_evmenkin@yahoo.com>

BUGS

     Most likely.  Please report if found.