Provided by: lam4-dev_7.1.4-7.2_amd64 bug

NAME

       introu - introduction to LAM user interface commands

LIST OF COMMANDS

       Name           Appears        Description
                      on Page

       bfctl          bfctl.1        Control message buffers (optional).
       bfstate        bfstate.1      Get message buffer status (optional).
       doom           doom.1         Deliver a signal (optional).
       fctl           fctl.1         Control remote file access (optional).
       fstate         fstate.1       Get remote file status (optional).
       hboot          hboot.1        Start LAM on a local node.
       mpicc          mpicc.1        Compile LAM C programs.
       mpiCC          mpicc.1        Compile LAM C++ programs.
       mpif77         mpif77.1       Compile LAM F77 programs.
       lamboot        lamboot.1      Start LAM.
       lamclean       lamclean.1     Clean all nodes.
       lamexec        lamexec.1      Run non-MPI programs.
       lamgrow        lamgrow.1      Add a node.
       lamhalt        lamhalt.1      Terminate LAM.
       lamshrink      lamshrink.1    Remove a node.
       lamtrace       lamtrace.1     Unload trace data.
       loadgo         loadgo.1       Execute program (optional).
       mpimsg         mpimsg.1       Display MPI buffered messages.
       mpirun         mpirun.1       Run an MPI application.
       mpitask        mpitask.1      Display MPI processes.
       recon          recon.1        Verify LAM setup.
       state          state.1        Get process status (optional).
       sweep          bfctl.1        Clean out message buffers (optional).
       tkill          tkill.1        Terminate local node LAM session.
       tping          tping.1        Echo messages to a node.
       lamwipe        lamwipe.1      Terminate LAM (deprecated; use lamhalt).

   Node Specification
       Target  nodes  are  given on the command line.  Nodes are generically identified as nlist,
       where list can be a single node identifier or a list of node identifiers.  For example:

              n1
              n1,3,5-10

       Additionally, clist can be used to list specific CPUs on a given  machine  (lamboot(1)  is
       used to specify how many CPUs LAM may use on each node).

       Node/CPU identifiers are established in the boot schema (see bhost(5)), and can be written
       in decimal or hexadecimal notation.  In addition to explicit node identification, LAM  has
       special mnemonics that refer to special nodes or a group of nodes.

       h       the local node where the command is typed (as in "here")

       o       the origin node where LAM was started with lamboot(1)

       N       all nodes

       C       all CPUs

   Process Specification
       LAM  processes  can  be  specified  in two ways: by process identifier from the underlying
       operating system or by LAM process index.  PIDs are written as plist, where list can be  a
       single  PID  or a list of PIDs.  Process indices are written as ilist, where list can be a
       single index or a list of indices.