NAME

       gpiomon - manual page for gpiomon v2.1.3

SYNOPSIS

       gpiomon [OPTIONS] <line>...

DESCRIPTION

       Wait for events on GPIO lines and print them to standard output.

       Lines are specified by name, or optionally by offset if the chip option is provided.

OPTIONS

       --banner
              display a banner on successful startup

       -b, --bias <bias>
              specify   the  line  bias  Possible  values:  'pull-down',  'pull-up',  'disabled'.
              (default is to leave bias unchanged)

       --by-name
              treat lines as names even if they would parse as an offset

       -c, --chip <chip>
              restrict scope to a particular chip

       -C, --consumer <name> consumer name applied to requested lines (default is 'gpiomon')

       -e, --edges <edges>
              specify  the  edges  to  monitor  Possible  values:  'falling',  'rising',  'both'.
              (default is 'both')

       -E, --event-clock <clock>
              specify  the  source  clock  for  event  timestamps  Possible  values: 'monotonic',
              'realtime', 'hte'.  (default is 'monotonic') By default 'realtime' is formatted  as
              UTC, others as raw u64.

       -h, --help
              display this help and exit

       -F, --format <fmt>
              specify a custom output format

       --idle-timeout <period>
              exit gracefully if no events occur for the period specified

       -l, --active-low
              treat the line as active low, flipping the sense of rising and falling edges

       --localtime
              format event timestamps as local time

       -n, --num-events <num>
              exit after processing num events

       -p, --debounce-period <period>
              debounce the line(s) with the specified period

       -q, --quiet
              don't generate any output

       -s, --strict
              abort if requested line names are not unique

       --unquoted
              don't quote line or consumer names

       --utc  format event timestamps as UTC (default for 'realtime')

       -v, --version
              output version information and exit

   Chips:
              A GPIO chip may be identified by number, name, or path.  e.g. '0', 'gpiochip0', and
              '/dev/gpiochip0' all refer to the same chip.

   Periods:
              Periods are taken as milliseconds unless units are specified. e.g. 10us.  Supported
              units are 's', 'ms', and 'us'.

   Format specifiers:
       %o     GPIO line offset

       %l     GPIO line name

       %c     GPIO chip name

       %e     numeric edge event type ('1' - rising or '2' - falling)

       %E     edge event type ('rising' or 'falling')

       %S     event timestamp as seconds

       %U     event timestamp as UTC

       %L     event timestamp as local time

AUTHOR

       Bartosz Golaszewski <brgl@bgdev.pl>

REPORTING BUGS

       Report bugs to:
           Bartosz Golaszewski <brgl@bgdev.pl>
           linux-gpio <linux-gpio@vger.kernel.org>

COPYRIGHT

       Copyright © 2017-2023 Bartosz Golaszewski License: GPL-2.0-or-later
       This  is free software: you are free to change and redistribute it.  There is NO WARRANTY,
       to the extent permitted by law.