NAME

       hackrf_sweep - control frequency sweep of hackrf

DESCRIPTION

       hackrf_sweep Usage:

              [-h]  #  this  help  [-d  serial_number]  #  Serial  number  of  desired HackRF [-a
              amp_enable] # RX RF amplifier 1=Enable, 0=Disable [-f freq_min:freq_max] #  minimum
              and  maximum frequencies in MHz [-p antenna_enable] # Antenna port power, 1=Enable,
              0=Disable [-l gain_db] # RX LNA (IF) gain, 0-40dB, 8dB steps [-g gain_db] # RX  VGA
              (baseband)  gain,  0-62dB,  2dB  steps  [-n  num_samples]  #  Number of samples per
              frequency, 8192-4294967296 [-w bin_width] # FFT bin width (frequency resolution) in
              Hz [-1] # one shot mode [-N num_sweeps] # Number of sweeps to perform [-B] # binary
              output [-I] # binary inverse FFT output -r filename # output file

   Output fields:
              date, time, hz_low, hz_high, hz_bin_width, num_samples, dB, dB, . . .

   Usage:
              [-h] # this  help  [-d  serial_number]  #  Serial  number  of  desired  HackRF  [-a
              amp_enable]  # RX RF amplifier 1=Enable, 0=Disable [-f freq_min:freq_max] # minimum
              and maximum frequencies in MHz [-p antenna_enable] # Antenna port power,  1=Enable,
              0=Disable  [-l gain_db] # RX LNA (IF) gain, 0-40dB, 8dB steps [-g gain_db] # RX VGA
              (baseband) gain, 0-62dB, 2dB  steps  [-n  num_samples]  #  Number  of  samples  per
              frequency, 8192-4294967296 [-w bin_width] # FFT bin width (frequency resolution) in
              Hz [-1] # one shot mode [-N num_sweeps] # Number of sweeps to perform [-B] # binary
              output [-I] # binary inverse FFT output -r filename # output file

   Output fields:
              date, time, hz_low, hz_high, hz_bin_width, num_samples, dB, dB, . . .

SEE ALSO

       The primary source of documentation is the wiki on github:

       https://github.com/mossmann/hackrf/wiki