NAME

       readsb - manual page for readsb version: 3.16 compiled on 250902

SYNOPSIS

       viewadsb [OPTIONS...]

DESCRIPTION

       vieadsb Mode-S/ADSB/TIS commandline viewer

       By  default,  viewadsb  will  TCP connect to 127.0.0.1:30005 as a data source.  Typical readsb / dump1090
       installs will provide beast data on port 30005.

   General options:
       --lat=<lat>
              Reference/receiver surface latitude

       --lon=<lon>
              Reference/receiver surface longitude

       --no-interactive
              Disable interactive mode, print to stdout

       --interactive-ttl=<sec>
              Remove from list if idle for <sec> (default: 60)

       --modeac
              Enable decoding of SSR Modes 3/A & 3/C

       --max-range=<dist>
              Absolute maximum range for position decoding (in nm, default: 300)

       --fix  Enable CRC single-bit error correction (default)

       --no-fix
              Disable CRC single-bit error correction

       --metric
              Use metric units

       --show-only=<addr>
              Show only messages by given ICAO on stdout

       --filter-DF=<type>
              Only network forward and display decoded ModeS messages on stdout only show this DF type

       --receiver-focus=<receiverId>
              only process messages from receiverId

       --cpr-focus=<hex>
              show CPR details for this hex

       --quiet
              Disable output (default)

       --debug=<flags>
              Debug mode (verbose), n: network, P: CPR, S: speed check

   Network options:
       --net-connector=<ip,port,protocol>
              Establish  connection,  can  be  specified  multiple  times  (viewadsb  default:   --net-connector
              127.0.0.1,30005,beast_in  viewadsb  first  usage  overrides  default,  second  usage  adds another
              input/output) Protocols: beast_out, beast_reduce_out,  beast_reduce_plus_out,  beast_in,  raw_out,
              raw_in,   sbs_in,  sbs_in_jaero,  sbs_out,  sbs_out_jaero,  vrs_out,  json_out,  gpsd_in,  uat_in,
              uat_replay_out, planefinder_in, asterix_in,  asterix_out  (one  failover  ip/address,port  can  be
              specified:  primary-address,primary-port,protocol,failover-address,failover-port) (any position in
              the comma separated list can also be either silent_fail or uuid=<uuid>)

   Help options:
       --help Give this help list

       --usage
              Give a short usage message

       Credits: antirez (original dump1090) Malcom Robb (work  on  his  dump1090  fork)  mutability  (forked  to
       dump1090-mutability  and  further  to dump1090-fa) Mictronics (readsb as a fork of dump1090-fa) wiedehopf
       (this fork of Mictronics readsb)

REPORTING BUGS

       Report bugs to Matthias Wirth <matthias.wirth@gmail.com>

readsb version: 3.16 compiled on 250902          September 2025                                        READSB(1)