NAME

       Config::Model::models::LCDd::serialVFD - Configuration class LCDd::serialVFD

DESCRIPTION

       Configuration classes used by Config::Model

       generated from LCDd.conf

Elements

   Brightness
       Set the initial brightness (4 steps 0-250, 251-500, 501-750, 751-1000)Optional. Type
       integer. upstream_default: '1000'.

   Device
       Device to use in serial mode. Usual values are /dev/ttyS0 and /dev/ttyS1. Optional. Type
       uniline. default: '/dev/ttyS1'.

   ISO_8859_1
       enable ISO 8859 1 compatibility Optional. Type boolean. upstream_default: 'yes'.

   OffBrightness
       Set the initial off-brightness This value is used when the display is normally switched
       off in case LCDd is inactive (4 steps 0-250, 251-500, 501-750, 751-1000)Optional. Type
       integer. upstream_default: '0'.

   Port
       Number of Custom-Characters. default is display type dependent Custom-Characters=0
       Portaddress where the LPT is. Used in parallel mode only. Usual values are 0x278, 0x378
       and 0x3BC.Optional. Type uniline. default: '0x378'.

   PortWait
       Set parallel port timing delay (us). Used in parallel mode only.Optional. Type integer.
       upstream_default: '2'.

   Size
       Specifies the size of the VFD.Optional. Type uniline. default: '20x2'.

   Speed
       set the serial port speed Optional. Type enum. choice: '1200', '2400', '9600', '19200',
       '115200'. upstream_default: '9600'.

   Type
       Specifies the displaytype.  0 NEC (FIPC8367 based) VFDs.  1 KD Rev 2.1.  2 Noritake VFDs
       (*).  3 Futaba VFDs 4 IEE S03601-95B 5 IEE S03601-96-080 (*) 6 Futaba NA202SD08FA (allmost
       IEE compatible) 7 Samsung 20S207DA4 and 20S207DA6 8 Nixdorf BA6x / VT100 (* most should
       work, not tested yet.)Optional. Type uniline. upstream_default: '0'.

   use_parallel
       "no" if display connected serial, "yes" if connected parallel.  I.e. serial by default.
       Optional. Type uniline. upstream_default: 'no'.

SEE ALSO

       •   cme