NAME

       iopl - change I/O privilege level

SYNOPSIS

       #include <sys/io.h>

       int iopl(int level);

DESCRIPTION

       iopl()  changes  the  I/O  privilege level of the calling process, as specified by the two
       least significant bits in level.

       This call is necessary to allow 8514-compatible X servers to run under Linux.  Since these
       X servers require access to all 65536 I/O ports, the ioperm(2) call is not sufficient.

       In  addition  to  granting unrestricted I/O port access, running at a higher I/O privilege
       level also allows the process to disable interrupts.  This will probably crash the system,
       and is not recommended.

       Permissions are inherited by fork(2) and execve(2).

       The I/O privilege level for a normal process is 0.

       This  call  is  mostly for the i386 architecture.  On many other architectures it does not
       exist or will always return an error.

RETURN VALUE

       On success, zero is returned.  On error, -1 is returned, and errno is set appropriately.

ERRORS

       EINVAL level is greater than 3.

       ENOSYS This call is unimplemented.

       EPERM  The calling process has insufficient privilege to call  iopl();  the  CAP_SYS_RAWIO
              capability is required to raise the I/O privilege level above its current value.

CONFORMING TO

       iopl()  is  Linux-specific  and  should  not  be  used in programs that are intended to be
       portable.

NOTES

       Libc5 treats it as a system call and has a prototype in <unistd.h>.  Glibc1 does not  have
       a  prototype.   Glibc2  has a prototype both in <sys/io.h> and in <sys/perm.h>.  Avoid the
       latter, it is available on i386 only.

SEE ALSO

       ioperm(2), outb(2), capabilities(7)

COLOPHON

       This page is part of release 3.54 of the Linux man-pages project.  A  description  of  the
       project,     and    information    about    reporting    bugs,    can    be    found    at
       http://www.kernel.org/doc/man-pages/.