NAME

       myson-diag  -  EEPROM  setup  and diagnostic program for ethernet cards based on the Myson
       MTD803 chip.

SYNOPSIS

       myson-diag [options]

DESCRIPTION

       myson-diag is a program that you can use to diagnose problems with ethernet cards based on
       the Myson MTD803 chip.

OPTIONS

       These  programs  follow the usual GNU command line syntax, with long options starting with
       two dashes (`-').  A summary of options is included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -q, --quiet
              Be very unverbose.

       -# <cardnum>
              Use card number <cardnum>.

       -a, --show_all_registers
              Print all registers.

       -e, --show-eeprom
              Dump EEPROM contents to stdout.

       -E, --emergency-rewrite
              Re-write a corrupted EEPROM.

       -p, --port-base <port>
              Specify port to use.

       -A, --Advertise <mediaype>
              Advertise media type. Valid Options are: 10baseT, 100baseT4, 100baseTx,  100baseTx-
              FD, 100baseTx-HD, 10baseT-FD and 10baseHD.

       -F, --new-interface <interface>
              Interface  number.  Options  that make sense are: 10baseT, 10base2, AUI, 100baseTx,
              10baseT-FDX, 100baseTx-FDX, 100baseT4, 100baseFx, 100baseFx-FDX, MII and Autosense.

       -H, --new-hwaddress <address>
              Set card to a new hardware address.

       -m, --show-mii
              Dump MII management registers.

       -R, --reset
              Reset the transceiver.

       -T, --test
              Do register and SRAM test.

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values. Do not use this, if you do not know
              what you do!

       -f, --force-detection
              Try to identify the card, even if it is active.

       -t, --chip-type <card>
              Explicitly  set the chip. To get all valid numbers, run myson-diag with the options
              '-t -1'.

SEE ALSO

       mii-diag(8)

AUTHOR

       myson-diag was written and is still maintained by Donald Becker <becker@scyld.com>.   This
       manual  page  was  written by Alain Schroeder <alain@debian.org>, for the Debian GNU/Linux
       system (but may be used by others).

                                        February 18, 2002                           MYSON-DIAG(8)