NAME

       mConcatFit - Merge multiple plane fit parameter files into one file

SYNOPSIS

       mConcatFit [-d] [-s statusfile] statfiles.tbl fits.tbl statdir

DESCRIPTION

       Merge  multiple  plane  fit parameter files (from mFitplane) into one file. This module is
       only needed in a Grid environment  where  the  mFitplane  jobs  may  run  in  parallel  on
       computers  that  do  not  share a file system. In this case, the fit parameters have to be
       merged into one file before mBgModel can be called.

BUGS

       This module have been used extensively but have not been  subject  to  the  same  rigorous
       testing  to which the core modules have been subjected. We advise users to contact Montage
       (montage@ipac.caltech.edu) before employing them to verify limitations in  their  use  and
       changes in the interfaces.

COPYRIGHT

       2001-2014 California Institute of Technology, Pasadena, California

       If  your  research  uses  Montage,  please  include  the  following acknowledgement: "This
       research made use of Montage. It is funded by the National Science Foundation under  Grant
       Number  ACI-1440620,  and  was  previously  funded  by  the National Aeronautics and Space
       Administration's Earth Science Technology Office, Computation Technologies Project,  under
       Cooperative  Agreement  Number  NCC5-626  between  NASA  and  the  California Institute of
       Technology."

       The Montage distribution includes an adaptation of the MOPEX algorithm  developed  at  the
       Spitzer Science Center.