NAME

       ubertooth-util - command line utility for Ubertooth Zero and Ubertooth One

SYNOPSIS

       ubertooth-util [options]

OPTIONS

       -a[0-7]
              get/set power amplifier level

       -b     get hardware board id number

       -c[2400-2483]
              get/set channel in MHz

       -C[0-78]
              get/set channel

       -d[0-1]
              get/set all LEDs

       -e     start repeater mode

       -f     activate flash programming (DFU) mode

       -h     display help message

       -i     activate In-System Programming (ISP) mode

       -I     identify ubertooth device by flashing all LEDs

       -l[0-1]
              get/set USR LED

       -m     display range test result

       -n     initiate range test

       -p     get microcontroller Part ID

       -q[1-225 (RSSI threshold)]
              start LED spectrum analyzer

       -r     full reset

       -s     get microcontroller serial number

       -S     stop current operation

       -t     intitiate continuous transmit test

       -U<0-7>
              set ubertooth device to use

       -v     get firmware revision number

       -V     get compile info

       -z     set squelch level

AUTHOR

       This  manual  page was written by Ruben Undheim <ruben.undheim@gmail.com> for the Debian project (and may
       be used by others).

                                                09 September 2015                              UBERTOOTH-UTIL(1)