Provided by: freebsd-manpages_10.1~RC1-1_all bug


     fpa, fea — device drivers for DEC FDDI controllers


     device fpa
     device fea

     FreeBSD only:
     device fddi


     The fpa and fea device drivers provide support for the DEC DEFPA PCI FDDI Controller and the
     DEC DEFEA EISA FDDI Controller, respectively.  All variants of either controller are
     supported including the DAS and SAS configurations.


     fea%d: error: desired IRQ of %d does not match device's actual IRQ (%d)  The device probe
     detected that the DEFEA board is configured for a different interrupt than the one specified
     in the kernel configuration file.

     fea%d: error: memory not enabled! ECU reconfiguration required  The device probe found that
     no device memory had been configured on the DEFEA.  Although the DEFEA can be configured
     with no device memory, this driver requires a minimum of 1K device memory to be set up.  The
     ECU (EISA Configuration Utility) will need to be run to change the settings.


     arp(4), netintro(4), ifconfig(8)


     The fpa and fea device drivers and this manual page were written by Matt Thomas.


     Normally, the device driver will not enable the reception of SMT frames.  However if the
     IFF_LINK1 flag is set, the device driver will enable the reception of SMT frames and pass
     them up to the Berkeley Packet Filter for processing.