Provided by: miredo-server_1.2.6-3_amd64 bug

NAME

       miredo-server.conf - configuration for miredo-server

SYNOPSIS

       miredo-server.conf

DESCRIPTON

       miredo-server.conf    is  the  configuration  file  for miredo-server.  Each configuration
       directive consists of one directive name, possibly followed by one or several spaces and a
       value  for  the  directive.   White  spaces,  empty  lines and lines starting with '#' are
       ignored.

       Directives are case-insensitive. A comprehensive list of the supported directives follows:

SERVER OPTIONS

       ServerBindAddress server_ip
              Specifies the primary IPv4 address of the Teredo server.  miredo-server  will  bind
              to UDP/IPv4 port 3544 on this address and waits for packets from Teredo clients. It
              will advertise the Teredo prefix which is defined with the Prefix directive.

              A Teredo server needs two subsequent IPv4 addresses. It  will  wait  for  UDP  IPv4
              packets  on  port  3544  on both addresses.  server_ip specifies the lowest of both
              IPv4 addresses, which is known as the primary IPv4 server  address.  The  secondary
              IPv4 address should be server_ip + 1 and must also be assigned to the server.

       ServerBindAddress2 server_ip2
              It  is  possible  to  specify  a  secondary IPv4 server address manually.  However,
              Miredo clients will need manual configuration (with the ServerAddress2 directive in
              miredo.conf). Other Teredo clients are believed not to support such setup.

       Prefix teredo_prefix
              This  directive  specifies  the  Teredo prefix which the Teredo relay and/or server
              will advertise.  teredo_prefix must be a valid IPv6 prefix.

              The default value is 2001:0000::.  A 32-bits prefix is required to use this option.
              Since  you  do  not  have  such  big  an  IPv6 prefix YOU WILL NOT USE THIS OPTION.
              Moreover, certain third party Teredo client  implementations  require  the  default
              prefix.

       InterfaceMTU mtu
              This directive overrides the value of the MTU that is advertised to Teredo clients.
              The default value is 1280 bytes and should not be changed  if  the  default  Teredo
              prefix is used.

              YOU  MUST  NOT  USE  THIS  OPTION  with  the  default  prefix.   This  would  break
              interoperability with most Teredo relays.

       SyslogFacility facility
              Specify which syslog's facility  is  to  be  used  by  miredo-server  for  logging.
              Possible  values  are: daemon (the default), local0, ... local7, kern and user (see
              syslog(2)).

SEE ALSO

       miredo-server(8)

AUTHOR

       RĂ©mi Denis-Courmont <remi at remlab dot net>

       http://www.remlab.net/miredo/