NAME

       fips-mode-setup - Check, enable, or disable the system FIPS mode.

SYNOPSIS

       fips-mode-setup [COMMAND]

DESCRIPTION

       fips-mode-setup(8) is used to check and control the system FIPS mode.

       When enabling the system FIPS mode the command completes the installation of FIPS modules if needed by
       calling fips-finish-install and changes the system crypto policy to FIPS.

       Then the command modifies the boot loader configuration to add fips=1 and boot=<boot-device> options to
       the kernel command line.

       When disabling the system FIPS mode the system crypto policy is switched to DEFAULT and the kernel
       command line option fips=0 is set.

OPTIONS

       The following options are available in fips-mode-setup tool.

       •   --enable: Enables the system FIPS mode.

       •   --disable: Disables the system FIPS mode.

       •   --check: Checks the system FIPS mode status.

       •   --is-enabled: Checks the system FIPS mode status and returns failure error code if disabled (2) or
           inconsistent (1).

       •   --no-bootcfg: The tool will not attempt to change the boot loader configuration and it just prints
           the options that need to be added to the kernel command line.

FILES

       /proc/sys/crypto/fips_enabled
           The kernel FIPS mode flag.

SEE ALSO

       update-crypto-policies(8), fips-finish-install(8)

AUTHOR

       Written by Tomáš Mráz.

fips-mode-setup                                    08/24/2019                                 FIPS-MODE-SETUP(8)