focal (8) sg_read_block_limits.8.gz

Provided by: sg3-utils_1.44-1ubuntu2_amd64 bug

NAME

       sg_read_block_limits - send SCSI READ BLOCK LIMITS command

SYNOPSIS

       sg_read_block_limits [--help] [--hex] [--raw]  [--readonly] [--verbose] [--version] DEVICE

DESCRIPTION

       Send  a  SCSI  READ  BLOCK LIMITS command to DEVICE and outputs the response. This command is defined for
       tape (drives) and its description is found in the SSC documents at http://www.t10.org .

OPTIONS

       Arguments to long options are mandatory for short options as well.

       -h, --help
              output the usage message then exit.

       -H, --hex
              output response in hex (rather than decode it).

       -r, --raw
              output response in binary to stdout.

       -R, --readonly
              open DEVICE in read-only mode. The default is to open it in read-write mode.

       -v, --verbose
              increase the level of verbosity, (i.e. debug output).

       -V, --version
              print the version string and then exit.

EXIT STATUS

       The exit status of sg_read_block_limits is 0 when it is successful. Otherwise see  the  sg3_utils(8)  man
       page.

EXAMPLES

       It  is usually okay to use no options. Here is an invocation (on the first line following the "#" command
       prompt) followed by some typical output:

          # sg_read_block_limits /dev/st0
       Read Block Limits results:
               Minimum block size: 1 byte(s)
               Maximum block size: 16777215 byte(s), 16383 KB, 15 MB

AUTHORS

       Written by Douglas Gilbert.

REPORTING BUGS

       Report bugs to <dgilbert at interlog dot com>.

       Copyright © 2009-2017 Douglas Gilbert
       This software is distributed under a FreeBSD license. There is NO warranty; not even for  MERCHANTABILITY
       or FITNESS FOR A PARTICULAR PURPOSE.

SEE ALSO

       sg3_utils(sg3_utils)