Provided by: radsecproxy_1.9.1-1build1_amd64 bug


       radsecproxy  -  a  generic RADIUS proxy that provides both RADIUS UDP and TCP/TLS (RadSec)


       radsecproxy [-c configfile] [-d debuglevel] [-f] [-i pidfile] [-p] [-v]


       radsecproxy is a generic RADIUS proxy that in addition to to usual RADIUS  UDP  transport,
       also  supports  TLS  (RadSec).  The aim is for the proxy to have sufficient features to be
       flexible, while at the same time to be small, efficient and easy to configure.

       The proxy was initially made to be able to deploy RadSec (RADIUS over  TLS)  so  that  all
       RADIUS  communication  across  network  links  could  be done using TLS, without modifying
       existing RADIUS software.  This can be done by running this proxy on the same host  as  an
       existing  RADIUS  server  or  client,  and configure the existing client/server to talk to
       localhost (the proxy) rather than other clients and servers directly.

       There are however other situations where a RADIUS  proxy  might  be  useful.  Some  people
       deploy RADIUS topologies where they want to route RADIUS messages to the right server. The
       nodes that do purely routing could be using a proxy. Some people may also wish to deploy a
       proxy  on  a  site boundary. Since the proxy supports both IPv4 and IPv6, it could also be
       used to allow communication in cases where some RADIUS nodes use only IPv4 and  some  only


       -f     Run in foreground.
              By specifying this option, the proxy will run in foreground mode. That is, it won't
              detach. Also all logging will be done to stderr.

       -d debuglevel
              This specifies the debug level. It must be set to 1, 2, 3, 4 or  5,  where  1  logs
              only  serious  errors,  and  5 logs everything. The default is 2 which logs errors,
              warnings and a few informational messages.

       -p     Pretend
              The proxy reads configuration files and performs initialisation as usual, but exits
              prior  to  creating  any  sockets. It will return different exit codes depending on
              whether the configuration files are okay. This may be used to verify  configuration
              files, and can be done while another instance is running.

       -v     Print version and exit.

       -c configfile
              This  option  allows you to specify which config file to use. This is useful if you
              want to use a config file that is not in any of the default locations.

       -i pidfile
              This option tells the proxy to create a PID file with the specified path.


       The proxy generally exits on all signals. The exceptions are listed below.

              When logging to a file, this signal forces a reopen of the log file.
              When using TLS or DTLS, reload certificate CRLs.

              This signal is ignored.



              The default configuration file.


       radsecproxy.conf(5), radsecproxy-hash(8)

                                           5 July 2018                             radsecproxy(8)