Provided by: manpages-dev_6.7-2_all bug

NAME

       readahead - initiate file readahead into page cache

LIBRARY

       Standard C library (libc, -lc)

SYNOPSIS

       #define _GNU_SOURCE             /* See feature_test_macros(7) */
       #define _FILE_OFFSET_BITS 64
       #include <fcntl.h>

       ssize_t readahead(int fd, off_t offset, size_t count);

DESCRIPTION

       readahead()  initiates readahead on a file so that subsequent reads from that file will be
       satisfied from the cache, and not block on disk I/O (assuming the readahead was  initiated
       early  enough  and  that  other activity on the system did not in the meantime flush pages
       from the cache).

       The fd argument is a file descriptor identifying the file which is to be read.  The offset
       argument  specifies  the  starting point from which data is to be read and count specifies
       the number of bytes to be read.  I/O is performed  in  whole  pages,  so  that  offset  is
       effectively  rounded  down  to  a  page  boundary  and  bytes are read up to the next page
       boundary greater than or equal to (offset+count).  readahead() does not  read  beyond  the
       end  of  the  file.   The file offset of the open file description referred to by the file
       descriptor fd is left unchanged.

RETURN VALUE

       On success, readahead() returns 0; on failure, -1 is returned, with errno set to  indicate
       the error.

ERRORS

       EBADF  fd is not a valid file descriptor or is not open for reading.

       EINVAL fd does not refer to a file type to which readahead() can be applied.

VERSIONS

       On  some 32-bit architectures, the calling signature for this system call differs, for the
       reasons described in syscall(2).

STANDARDS

       Linux.

HISTORY

       Linux 2.4.13, glibc 2.3.

NOTES

       _FILE_OFFSET_BITS should be defined to be 64 in code that uses a pointer to readahead,  if
       the  code  is  intended  to  be portable to traditional 32-bit x86 and ARM platforms where
       off_t's width defaults to 32 bits.

BUGS

       readahead() attempts to schedule the reads  in  the  background  and  return  immediately.
       However,  it  may  block  while  it  reads  the  filesystem  metadata needed to locate the
       requested blocks.  This occurs frequently with ext[234]  on  large  files  using  indirect
       blocks  instead of extents, giving the appearance that the call blocks until the requested
       data has been read.

SEE ALSO

       lseek(2), madvise(2), mmap(2), posix_fadvise(2), read(2)