plucky (3) POE::Filter::Block.3pm.gz

NAME

       POE::Filter::Block - translate data between streams and blocks

SYNOPSIS

         #!perl

         use warnings;
         use strict;
         use POE::Filter::Block;

         my $filter = POE::Filter::Block->new( BlockSize => 8 );

         # Prints three lines: abcdefgh, ijklmnop, qrstuvwx.
         # Bytes "y" and "z" remain in the buffer and await completion of the
         # next 8-byte block.

         $filter->get_one_start([ "abcdefghijklmnopqrstuvwxyz" ]);
         while (1) {
           my $block = $filter->get_one();
           last unless @$block;
           print $block->[0], "\n";
         }

         # Print one line: yz123456

         $filter->get_one_start([ "123456" ]);
         while (1) {
           my $block = $filter->get_one();
           last unless @$block;
           print $block->[0], "\n";
         }

DESCRIPTION

       POE::Filter::Block translates data between serial streams and blocks.  It can handle fixed-length and
       length-prepended blocks, and it may be extended to handle other block types.

       Fixed-length blocks are used when Block's constructor is called with a BlockSize value.  Otherwise the
       Block filter uses length-prepended blocks.

       Users who specify block sizes less than one deserve what they get.

       In variable-length mode, a LengthCodec parameter may be specified.  The LengthCodec value should be a
       reference to a list of two functions: the length encoder, and the length decoder:

         LengthCodec => [ \&encoder, \&decoder ]

       The encoder takes a reference to a buffer and prepends the buffer's length to it.  The default encoder
       prepends the ASCII representation of the buffer's length and a chr(0) byte to separate the length from
       the actual data:

         sub _default_encoder {
           my $stuff = shift;
           substr($$stuff, 0, 0) = length($$stuff) . "\0";
           return;
         }

       The corresponding decoder returns the block length after removing it and the separator from the buffer.
       It returns nothing if no length can be determined.

         sub _default_decoder {
           my $stuff = shift;
           unless ($$stuff =~ s/^(\d+)\0//s) {
             warn length($1), " strange bytes removed from stream"
               if $$stuff =~ s/^(\D+)//s;
             return;
           }
           return $1;
         }

       This filter holds onto incomplete blocks until they are completed in a framing buffer.  To control memory
       usage, a maximum framing buffer size is imposed.  This maximum size defaults to 512 MB (512*1024*1024
       octets).  You may change this size limit with the "MaxBuffer" parameter.

           MaxBuffer => 1099511627776  # One terabyte!

       The size of each individual block is also limited.  By default, each block may be no more then 64 MB.
       You may change this size limit with the "MaxLength" parameter.

           MaxLength => 10             # small blocks

       Remember that MaxBuffer needs to be larger then MaxLength.  What's more, it needs to have room for the
       length prefix.

       If either the "MaxLength" or "MaxBuffer" constraint is exceeded, "POE::Filter::Bock" will throw an
       exception.

PUBLIC FILTER METHODS

       POE::Filter::Block has no additional public methods.

SEE ALSO

       Please see POE::Filter for documentation regarding the base interface.

       The SEE ALSO section in POE contains a table of contents covering the entire POE distribution.

BUGS

       The put() method doesn't verify block sizes.

AUTHORS & COPYRIGHTS

       The Block filter was contributed by Dieter Pearcey, with changes by Rocco Caputo.

       Please see POE for more information about authors and contributors.